
N116-133 AquaMetrix 2300 Installation and Operation Manual Page 7
Pressing the Down arrow will cycle through all of the individual probe screens. Pressing the
Enter button will bring up a Meter Action screen, allowing the user to acknowledge an alarm,
if active, or setting relay trip points.
Run button will bring up the Run screen once again.
Figure 1 - The Run display on the left reports 4 process values at a time. If there are more than 4
pressing the down button reveals these. The identical image appears on the web browser. The
Detail display on the right shows the detailed status of the Tank pH condition.
1.4. Front Panel Menu
The front panel menu is limited to a select group of functions. The outline of this menu
structure is below, with descriptions.
Unit name, IP address, software version, and system status
information
Manually disable, enable, or calibrate defined probes
Save or restore the unit configuration and setup to a
removable SD card
Powers down and restarts controller
After a confirmation dialog is confirmed, all probes are
disabled, all logs are closed, and the system is put in a state
where it is safe to remove power from the controller.
Change the network between Dynamic (DHCP) and Static IP
DHCP or Static IP; allows manual entry of static IP data
Allows entry of port number
Confirm or cancel choices
Multi-Parameter Controller
Menu
Back
Enter
Run
AquaMetrix 2300
Tank pH
7.35
Tank ORP
386
Tank D.O.
3.92
Tank Level
88
pH
mV
ppm
cm
Komentáře k této Příručce