Aquametrix 2200C Conductivity Controller User Manual Uživatelský manuál stáhnout pdf (Strana 11)

4.7.1 The controls which are frequently used in the normal operation of the instrument are

all accessible on the control panel. Some switches, which are infrequently used,

are located on the back of the main circuit board.

4.7.2 The DIP switches are scanned only on power-up and every time the instrument is

taken out of the menu mode. Therefore, after changes to the DIP switch settings,

you must bring up the menu by pressing CALL, and then return the instrument to

the online mode by pressing RUN, in order for the instrument to scan the new DIP

values.

4.7.3 The following table describes the use of the 16 DIP switches:

Bank S1

Dip Switch

Description

OFF

Selects temperature unit

°C

°F

Password Feature

Disabled

Enabled

Fail-Safe mode for Relay A

Enabled

Disabled

Direction of Control for Relay A

Falling

Rising

Alarm Relay to be activated for memory loss

Disabled

Enabled

Fail-Safe mode for Alarm Relay

Enabled

Disabled

Auto return from menu

Enabled

Disabled

0-5V / 0-1mA Select

Conductivity

Temperature

Bank S2

Dip Switch

Description

OFF

Cycling Control for Relay A

Enabled

Disabled

Reserved

Note: Items in “BOLD” are the factory settings that the unit will be shipped with.

4.8 Output Hold

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Aquametrix 2200C Conductivity Controller User Manual Uživatelský manuál Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Příslušenství pro vodu Aquametrix 2200C Conductivity Controller User Manual